There is also maintenance personnel who first took off the handrail and measured it. Such a measuring method. It is inaccurate and very laborious. The escalator must stop running and wait for the newly purchased handrails to arrive. I will share with you a simple and labor-saving measurement method, and I hope to help the escalator repair and maintenance colleagues.
First: Preparation
1. This work is performed by at least two employees and must be performed by professional escalator repair and maintenance operators.
2. Prepare and prevent the guardrails of the upper and lower platforms, and set the escalator to stop using warning signs to prevent passengers from entering by mistake.
3. Prepare a watercolor pen.
4. A steel tape ruler over 3 meters.
Second: Measurement
1. This operation must be performed on the non-curved handrail area of the escalator's ramp section.
2. The escalator can be operated in both automatic operation and maintenance model. Use maintenance operations as much as possible so that the escalator can be controlled and stopped accurately.
3. Generally, the escalator is suitable to run in an upward direction, and the operation is more convenient.
4. On the non-curved area of the handrail on the upper end of the escalator, draw a baseline with a watercolor pen in front and back, and mark "0" and 0 meters.
5. Measure from the side of “0” down to the non-curved section of the lower handrail.
6. Draw a line on the handrail as the next start point.
7. Mark the length on the rule.
8. The escalator runs upwards.
9. When running, be careful not to place the line marked with the length mark just above the arc area, and stop the escalator.
10. Measure down to the non-curved area of the lower handrail with a ruler at the position marked with the length mark.
11. Measure the length plus the position of the length just marked, and then draw a marking straight line on the handrail.
12. The length values added on the table.
13. Repeat steps 9 to 12 while moving the escalator up
14. Until the "0" mark appears on the surface of the handrail.
15. Measuring the length of the position marked by "0" up to this point is the total length of the handrail.
Third. A new handrail can be purchased according to the measured length.
Fourth: The length of the new handrails ordered at the time of purchase should not be longer than the total length of this measurement. It is slightly shorter by a few centimeters.
You can compensate by adjusting the tensioning device of the handrail during installation.
If the length exceeds this length, the tensioning device may be adjusted to the limit. Replacement is troublesome.
Also, we add the handrail inner size illustration picture.
Any questions, please contact us. Whatsapp: +86 13917269114
We will do our best to reply to your question.